Identify the 4 cap head screws located on the right side of the extruder. Unplug your printer from the power source.ġ.Revo hotend with a spring, adaptor and nozzle.īefore you start the upgrade, make sure to do the following steps:.Probe spacer and its corresponding screws.Your upgrade kit will have the following components: E3D parts are intended for indoor use only, we cannot be responsible for issues caused through the operation of our products outside.However, in most cases, our HotEnds and Extruders are not official drop-in replacements and will most likely void the warranty you have with your printer manufacturer. Users should be mindful that these guides aim to make it easier to mount our HotEnds and Extruders to your printers. We provide these guides as a reference to show that it is possible to mount E3D products to various 3D printers.We cannot be held responsible for damages caused by the use, misuse or abuse of our products. Your HotEnd and your printer are your responsibility.Connecting 12v parts to a 24v power supply can result in overheating, component damage, or fire if you are unsure double check the rating on your power supply.Make sure you have ordered and received the correct voltage heater and fan to match your printer's power supply.The standard Revo HeaterCore can print up to 300☌, do not exceed these temperatures!.Do not change the Revo nozzle whilst hot always wait to cool to room temperature.Be aware when you heat up your new HotEnd not to burn yourself on the HeaterCore or Nozzle.We advise disconnecting from the mains during installation and maintenance. Please don't work on your printer while it's turned on.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |